The Correct Cleaning Method For A Necktie

　　Necktie is one of the accessories commonly used by men, especially on many formal occasions, the existence of a necktie is indispensable. Although many people know how to use neckties, few people know how to clean and maintain neckties. If the cleaning method of the necktie is not correct, a good necktie may be ruined. The following is the correct cleaning method for the necktie we have collected and sorted out. Welcome everyone to learn from and refer to, and hope to be helpful to everyone.

　　One: When washing the necktie with water

　　1 Soak the necktie in warm soapy water at about 30°C for 1-3 minutes, then gently scrub along the necktie lines with a brush, do not brush hard or rub it arbitrarily, and use clean water at 30°C after cleaning Rinse well. Then press the above method for ironing. If the necktie is out of shape after washing, you can disassemble the stitches at the back of the necktie, iron the fabric and interlining of the necktie flat, and then sew it up as it is.

　　Two: When dry cleaning the necktie

　　You can take a medicated cotton ball dipped in a little alcohol or gasoline, wipe it gently to remove stains, and then put a wet white cloth on it and iron it with an electric iron. The temperature when ironing depends on the material used in the necktie. When ironing chemical fiber fabrics, the temperature should not be too high (below 70°C); the temperature of wool silk can be higher (below 170°C).

　　Three: Remove blood and milk

　　Use a mixture of soap and gasoline (without water) to apply on the color stains, rub gently to make them dissolve and fall off, then wash with soapy water, and rinse with clean water. If after washing with soap, the grease has been removed and the color is still there, it should be faded. Use bleaching powder or hydrosulfite (for silk neckties) to remove color stains.

　　Four: When scrubbing the necktie

　　You can make a model according to the size of the necktie with glued paper or thin plywood, put the necktie on the model, and gently scrub the necktie with a soft brush dipped in detergent. Then rinse and brush with clean water (be sure to clean). After washing, let it dry for a while, then line it with a white damp cloth and iron it with an iron. The model can then be removed. In this way, the necktie will not be deformed, and it will be as smooth as new.

　　Five: In addition to printing oil stains

　　Use a mixture of soap and gasoline (without water) to apply on the color stains, rub gently to make them dissolve and fall off, then wash with soapy water, and rinse with clean water. If after washing with soap, the grease has been removed and the color is still there, it should be faded. Use bleaching powder or sodium bicarbonate (for silk neckties) to remove color stains.

　　Six: Remove tea and coffee stains

　　If coffee or tea is spilled on the necktie, if you take it off immediately and wash it with hot water, it can be washed clean. If the stain is dry, it is necessary to wash with a more complicated method. Use a mixed solution of glycerin and egg yolk to wipe the stains, wait for a little dry, and then wash with water.

　　Finally, because the knitted tie fabric is different from the lining, it is easy to wrinkle after washing, and it is also easy to damage the luster of the surface of the knitted tie. Do not wash the whole knitted ties in water, and it is best to use dry cleaning.